Panel & Foam Adhesive (LN-609)

This fast-bonding adhesive is like an extra set of hands providing a sure hold, precision placement and less nailing. Excellent as a wall adhesive, it offers 10 minutes of working time and an impact-resistant bond.


fast-bonding adhesive:  Panel & Foam wall adhesive

Key Features

Recommended For:

use as a wall adhesive for paneling, foamboard, MDF board and paneling, wainscoting, corkboard, wood, foam and plastic molding, and all types of insulation board.

NOT Recommended For:

uses other than paneling, molding, foamboard or EIFS installation, or use between two non-porous surfaces.

Available Sizes

  • 10 oz. cartridge


  • 10 oz. cartridge covers 32 lineal ft.


43 GPL


ASTM C-557

*Please note that the typical dry time for most construction adhesives is approximately 24 hours. This may vary due to temperature, humidity amount of product applied and surface porosity.

Get Adobe Reader to view certain LIQUID NAILS Adhesive product info

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

Surface Preparation

All panels must be separated and conditioned to room temperature for 48 hours prior to installation. Preparation: Surfaces must be clean, dry and structurally sound before application of this fast-bonding adhesive. Cut and pre-fit materials prior to installation.


1. Cut nozzle at a 45? angle to desired bead size (marked on nozzle). 2. Puncture inner seal with nail or wire. 3. Adhere materials within 20 minutes of gunning fast-bonding adhesive. Due to panel inconsistencies, for best results, bracing and/or nailing may be required. Humidity may extend dry time of fast-bonding adhesive. Instant-grab method: Paneling — Apply 1/4" bead of fast-bonding adhesive approximately 1" from edge of panel around the perimeter. Apply two zig-zag 1/4" beads of fast-bonding adhesive in the middle of the panel. Press panel firmly into place. Remove panel from wall for one minute. Rejoin panel to wall. Molding — Apply 1/4" zig-zag bead of fast-bonding adhesive to back of molding. Press molding firmly into place. Starting at one end, nail every 12".


If this fast-bonding adhesive is wet, use water promptly. If the fast-bonding adhesive has dried, scrape it away, then remove residue using a cloth dampened with mineral spirits.

Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.

Price and item availability may vary.