=
 
 
 

Ceramic Tile (LN-321)

This ceramic tile adhesive features a non-slip formula that makes it perfect for bonding floor and wall tiles indoors.

 

Ceramic Tiles

Key Features

Recommended For

Bonding ceramic tiles (pavers, quarry tiles, mosaic, slate) on walls & floors

NOT Recommended For

Tiles larger than 20 x 20 cm (8 x 8 in.), asphalt, particle boards or outdoor uses

Available Sizes

  • 946 mL
  • 3.78 L

Coverage

  • 946 mL quart covers 0.8 - 0.9 square metres (8.8 - 10.0 square feet) Using a 6 mm (1/4 in) square trowel on heavy tiles (20 x 20 cm or 8 x 8 in max.) or rough surfaces.
  • 946 mL quart covers 0.9 - 1.1 square metres (10.0 - 11.3 square feet) Using a 4 x 5 mm (5/32 x 3/16 in) sawtooth trowel on walls.
  • 946 mL quart covers 1.5 - 1.6 square metres (16.3 - 17.5 square feet) Using a 3 mm (1/8 in) sawtooth trowel on floors.
  • 3.78 L gallon covers 3.2 - 3.7 square metres (35.0 - 40.0 square feet) Using a 6 mm (1/4 in) square trowel on heavy tiles (20 x 20 cm or 8 x 8 in max.) or rough surfaces.
  • 3.78 L gallon covers 3.7 - 4.2 square metres (40.0 - 45.0 square feet) Using a 4 x 5 mm (5/32 x 3/16 in) sawtooth trowel on walls.
  • 3.78 L gallon covers 6.0 - 6.5 square metres (65.0 - 70.0 square feet) Using a 3 mm (1/8 in) sawtooth trowel on floors.

Use

Interior
 
Get Adobe Reader to view certain LIQUID NAILS Adhesive product info

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

Clean-up

Wet product: Soap and water.
Dry product: Scraper and mineral spirits.

Storage

Between 5°C (40°F) and 35°C (95°F) in a dry area. Keep container hermetically closed when not in use.

Surface Preparation

Materials, adhesive and room must be maintained at a temperature between 15°C (60°F) and 30°C (85°F) for at least 24 hours before installation and for a few days afterward. Surfaces should be smooth, clean, dry and free from oil, grease, wax, paint, varnish or all contaminants.

Product Application

Spread adhesive evenly over the surface using the recommended trowel. Allow 15 minutes for adhesive to set and bond within 45 minutes. Wall: Install the tiles from top to bottom. Firmly press the panel to the adhesive while sliding it slightly. Floor: Set tile and tamp immediately with a padded block. Note: Always use a trowel so that 80% of the back of the material is covered with adhesive once it is in place.

Working Time

45 minutes. Very warm temperatures or an improper trowel will affect working time. Wait 24 hours before grouting or walking on the floor. Wait longer if tile is set on dense or cold floors. Fully cures within 10 days.

Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.

Price and item availability may vary.

 
 
 
;